en:zb3cx_v1
Differences
This shows you the differences between two versions of the page.
|
en:zb3cx_v1 [2022/01/22 11:38] Dmitriy created |
en:zb3cx_v1 [2022/01/22 19:56] (current) Dmitriy |
||
|---|---|---|---|
| Line 29: | Line 29: | ||
| Module pin assignment (top view): | Module pin assignment (top view): | ||
| - | {{:: | + | {{: |
| ^ Module pin ^ Microcontroller assignment/ | ^ Module pin ^ Microcontroller assignment/ | ||
| Line 61: | Line 61: | ||
| ===== Module Software ===== | ===== Module Software ===== | ||
| - | See documentation for supported firmware: [[::cc2538_firmware]] | + | See documentation for supported firmware: [[cc2538_firmware]] |
| ===== Module firmware procedure ===== | ===== Module firmware procedure ===== | ||
| - | The cc2538-bsl utility can be used to flash the module (see [[::cc2538_bsl_manual]]) | + | The cc2538-bsl utility can be used to flash the module (see [[cc2538_bsl_manual]]) |
| Before flashing, the module must be switched to bootloader mode (serial bootloader). To do this, you need to reset the module by holding a low logic level at the input PA7 of the microcontroller (pin 20 of the module). The module is switched back to the operating mode when the module is turned on/rebooted at a high logic level at pin PA7 (pin 20 of the module). | Before flashing, the module must be switched to bootloader mode (serial bootloader). To do this, you need to reset the module by holding a low logic level at the input PA7 of the microcontroller (pin 20 of the module). The module is switched back to the operating mode when the module is turned on/rebooted at a high logic level at pin PA7 (pin 20 of the module). | ||
en/zb3cx_v1.1642840720.txt.gz · Last modified: 2022/01/22 11:38 by Dmitriy
Page Tools
