Differences

This shows you the differences between two versions of the page.

--- en:jethub_h1 [2022/01/25 17:12]
Leonid Titov
+++ en:jethub_h1 [2022/02/02 19:46] (current)
Leonid Titov
@@ Line 1: / Line 1: @@
-FIXME **This page is not fully translated, yet. Please help completing the translation.**\\ //(remove this paragraph once the translation is finished)//
 ======JetHub H1======
@@ Line 109: / Line 107: @@
 The JetHome JetHub H1 controller uses a Zigbee wireless communication module based on a TI CC2538 + CC2592 or TI CC2652P1 chip. See module description: [[zb3cx_v1]] or [[zb6c_v1]]
-The module is connected to the UART_AO_B port of the processor (the device is displayed in the system as **/dev/ttyAML2**), hardware receive/transmit control (RTS and CTS lines) is not used. It is possible to control the hardware reset of the wireless module (RESET line) and control its boot mode (BOOT line) using the system GPIO interface.
+The module is connected to the UART_AO_B port of the processor (the device is presented in the system as **/dev/ttyAML2**), hardware receive/transmit control (RTS and CTS lines) is not used. It is possible to control the hardware reset of the wireless module (RESET line) and control its boot mode (BOOT line) using the system GPIO interface.
 A 2x5 connector with a pin pitch of 1.27mm is installed on the board for JTAG flashing:

JetHome wiki