This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | |||
en:h1_housing_opening_howto [2022/01/22 20:04] Dmitriy |
en:h1_housing_opening_howto [2022/02/02 20:56] (current) Leonid Titov |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | FIXME **This page is not fully translated, yet. Please help completing the translation.**\\ //(remove this paragraph once the translation is finished)// | ||
- | |||
====== How to open the JetHome JetHub H1 controller case? ====== | ====== How to open the JetHome JetHub H1 controller case? ====== | ||
- | The body of the JetHome JetHub H1 controller consists of two parts: the lower part, in which the printed circuit board is fixed, and the cover. The parts of the case are fastened together using 8 latches inside the case. The lower part of the housing (view from the inside, the arrows indicate the location of the latches): | + | The case of the JetHome JetHub H1 controller consists of two parts: the lower part, in which the printed circuit board is fixed, and the cover. The parts of the case are fastened together using 8 latches inside the case. The lower part of the housing (view from the inside, the arrows indicate the location of the latches): |
{{: | {{: | ||
Line 11: | Line 9: | ||
{{: | {{: | ||
- | To open the case, you can use a thin flat screwdriver or a special | + | To open the case, you can use a thin flat screwdriver or a special |
{{: | {{: |