Differences

This shows you the differences between two versions of the page.

--- en:h1_housing_opening_howto [2022/01/22 12:11]
Dmitriy created
+++ en:h1_housing_opening_howto [2022/02/02 20:56] (current)
Leonid Titov
@@ Line 1: / Line 1: @@
-FIXME **This page is not fully translated, yet. Please help completing the translation.**\\ //(remove this paragraph once the translation is finished)//
 ====== How to open the JetHome JetHub H1 controller case? ======
-The body of the JetHome JetHub H1 controller consists of two parts: the lower part, in which the printed circuit board is fixed, and the cover. The parts of the case are fastened together using 8 latches inside the case. The lower part of the housing (view from the inside, the arrows indicate the location of the latches):
+The case of the JetHome JetHub H1 controller consists of two parts: the lower part, in which the printed circuit board is fixed, and the cover. The parts of the case are fastened together using 8 latches inside the case. The lower part of the housing (view from the inside, the arrows indicate the location of the latches):
-{{::h1_housing_opening_1.jpg?400|}}
+{{:h1_housing_opening_1.jpg?400|}}
 Housing cover (inside view):
-{{::h1_housing_opening_2.jpg?400|}}
+{{:h1_housing_opening_2.jpg?400|}}
-To open the case, you can use a thin flat screwdriver or a special spatula. It is better to start opening the case from the latch located in the corner of the case:
+To open the case, you can use a thin flat screwdriver or a special tool. It is better to start opening the case from the latch located in the corner of the case:
-{{::h1_housing_opening_3.jpg?400|}}
+{{:h1_housing_opening_3.jpg?400|}}
 Next, go to the latch on the edge of the case:
-{{::h1_housing_opening_4.jpg?400|}}
+{{:h1_housing_opening_4.jpg?400|}}
 And so on, sequentially open all the latches around the perimeter of the case.

JetHome wiki

User Tools

Site Tools

Differences

Page Tools