Differences

This shows you the differences between two versions of the page.

--- en:efr32mg21_flash_manual [2022/01/22 11:46]
Dmitriy created
+++ en:efr32mg21_flash_manual [2022/02/02 20:04] (current)
Leonid Titov
@@ Line 1: / Line 1: @@
-FIXME **This page is not fully translated, yet. Please help completing the translation.**\\ //(remove this paragraph once the translation is finished)//
 ====== Instructions for flashing EFR32MG21 microcontrollers ======
@@ Line 7: / Line 5: @@
 The bootloader is flashed via the JTAG interface. To flash the bootloader, you can use the utility [[https://www.silabs.com/developers/mcu-programming-options|Simplicity Comander]]
-Linux version of the utility: [[https://www.silabs.com/documents/public/software/SimplicityCommander-Linux.zip|SimplicityCommander-Linux.zip]]
+Linux version of the utility can be found here: [[https://www.silabs.com/documents/public/software/SimplicityCommander-Linux.zip|SimplicityCommander-Linux.zip]]
 Unzip the archive and run the utility. If the firmware procedure is performed using the Silicon Labs debug board, then information about it should be displayed in the "Kit" window, for example:
@@ Line 19: / Line 17: @@
 </code>
-To flash the bootloader, open the "Flash" tab, select the desired file for flashing with the "Browse ..." button and flash the bootloader with the "Flash" button
+To flash the bootloader, open the "Flash" tab, select the desired image file for flashing with the "Browse ..." button and flash the bootloader with the "Flash" button
 ===== Write main firmware =====
@@ Line 67: / Line 65: @@
 </code>
-After successful firmware, if you check the status of the board:
+After successful firmware, you can check the status of the board:
 <code>
 python3 Elelabs_EzspFwUtility.py probe -p /dev/ttyUSB0
 </code>
-Will output:
+Normal output will show something like this:
 <code>
 /12/01 01:01:59 Elelabs_EzspFwUtility: Generic EZSP adapter detected:

JetHome wiki

User Tools

Site Tools

Differences

Page Tools