This is an old revision of the document!
This page is not fully translated, yet. Please help completing the translation.
(remove this paragraph once the translation is finished)
Burning Tool is a program for flashing devices based on Amlogic processors. Used for low-level firmware, using the bootloader built into the processor. The program is installed using the installer, like other software under Windows OS. Administrator rights are required for installation. During installation, the program also installs the required driver.
You can download the program at: http://update.jethome.ru/tools/USB_Burning_Tool_v2.2.3.zip
Appearance of the main program window:
For flashing, the device must be connected with a USB Type A - USB Type A cable to a PC. The controller is also powered during the firmware via this USB cable and it is not necessary to connect the main power source. Some devices have more than one USB port. See the instructions for your device to find out through which USB port the device is connected for firmware.
For flashing, the device must be booted in bootloader mode (update mode). This can be done in several ways:
After the device is successfully connected to the PC and identified in the Burning Tool program, the inscription “Connect success” will be displayed in the main program window.
Open the menu “File” → “Import image” and select the image for the firmware on the disk. The image will be verified, this may take a long time.
If no errors are found during the verification process, then the program will not display any messages at the end of the verification.
Для начала прошивки образа небходимо кликнуть кнопку “Start” в правом верхнем углу главного окна программы. Начнется процесс прошивки.
Если при прошивке образа HassOS возникают ошибки, то необходимо перед началом процесса прошивки отключить галочку “Erase flash”.
При возникновении какой-либо ошибки процесс прерывается и в нижней части окна программы будут выведены сообщения с описанием ошибки.
По завершению процесса прошивки будет выведено сообщение: “Burning successfull”.
После чего можно кликнуть на кнопку “Stop”, запретив автоматический запуск процедуры прошивки при новом подключении устройства к ПК.